Press Release: YPS Celebrates Breakthrough in Low Energy Electron Cryo-Microscopy Please Read ›
YPS / Technical / Schottky Field Emission FAQS

Schottky Field Emission Sources FAQ

Frequently asked questions about field emission sources

image8.png

Q. Are FE sources less reliable than thermionic sources?

A. No - they can be very reliable, working continuously over many months.


Q. What are the advantages of Schottky field emission compared to cold field emitters e.g. W(310) or W(111)?

A. The major advantages are better beam current stability, less stringent vacuum requirements and the fact that there is no need for periodic emitter flashing to restore the emission current.


Q. What are the vacuum requirements for operation of a Schottky field emission source?

A. Normally 10-9 mbar or better in the source region.




Q. What are the brightness levels of Schottky sources compared to thermionic sources?

A. Schottky field emitters have brightness of about 108Acm-2sr-1 whereas thermionic emitters have about 105 Acm-2sr-1.



Q. Do Schottky emitters need replacing very frequently?

A. The lifetime of a Schottky emitter is determined by the life of the Zr reservoir in the tip structure. This is normally about 8000 hours.


Q. Are there special steps to be taken in turning on a Schottky source?

A. Care is needed to avoid thermal shock to the emitter and to avoid electrical breakdown transients as the extraction voltage is applied. Further, the operating temperature should not exceed 1850 K.


Q. Can any thermionic source be replaced by a Schottky field emitter?

A. In principle, yes. There may be a need for differential pumping of the source in order to maintain adequately low pressure.